top of page

Use Uni-motion

Here, we describe the necessary procedures when using Uni-motion on a regular basis.

Start SteamVR/Uni-studio.

  1. Launch SteamVR.

  2. Start Uni-studio.

 

* At this time, be sure to start SteamVR first.

Start SteamVR/Uni-studio.

*When changing Uni-studio settings, be sure to turn on the power of all Un-Sensors. If the Uni-sensor is powered off, the setting changes will not be reflected.

Recommended settings are:

 

① Magnetic compensation: OFF
② Refresh rate: 60 (LP)
③ Limit Joint Angle: ON
④ Auto correct: ON


The default setting for magnetic correction is ON, but if you are using it for the first time, we recommend turning it OFF.

b5.jpg

Initial tracker setup

Perform the initial settings of the tracker from the setting screen.
① Open the setting screen from the gear icon at the bottom right of the screen.

b1.jpg

2. From the menu on the left side of the screen, open "Operation Mode" and click "FBT Default".

b2.png

③ Select "Trackers" from the menu on the left side of the screen, and click "Set default for FBT mode".

b3.png

④Close the setting screen, return to the top screen, and confirm that the avatar is displayed on the screen.

b4.png

​Attach the sensor to the body

Put the Uni-sensor in the sensor holder and put on the belt. Install the Uni-sensor in the correct position by referring to the sensor number sticker and the image below. The image is viewed from the front.

​*The chest and waist belts are worn so that the Uni-sensor is in front.

*Thigh and shin belts can be worn quickly by making a loop with the belt first and then passing your feet through the loop.​

センサー取付位置v2.png

Recommended mounting position of the sensor belt

 

  • ​The chest sensor can be placed anywhere above the abdomen, but it is difficult to drop if it is attached as high as possible.

 

  • Place the waist sensor at the same position as the line for wearing belts such as trousers or lower. When attached to the abdomen, the motion of the foot becomes very unstable. ​

​

  • By attaching the (thigh) sensor as high as possible, it will not fall off easily.

​

  • The lower leg (shin) sensor should be attached to the upper part of the leg, not the ankle, to avoid the magnetic effect of the floor.

Wear and calibrate the Uni-sensor

・Please wait 10 to 20 seconds after powering on the Uni-sensor before performing calibration.

​​・Please make sure that the chest sensor is installed parallel to the chest plate..

1. Turn on the Uni-sensor, then click the "Calibrate" button on the Uni-studio top screen.

* The image is when 8 Uni-sensors are connected.

b16.jpg

2. Follow the on-screen instructions to calibrate.

​Please calibrate the I-pose, S-pose and feet in order.

13.png

*If the HMD cannot be connected/tracked

​Please refer to Q&A "HMD cannot be connected/tracked".

Launch the ​SteamVR game.

Start the game from SteamVR. When using a game that supports full body tracking, please perform calibration corresponding to each game in the game.

​

When using with VRChat,please refer to the Use with VRChat.

​

bottom of page