pairing

I will explain how to pair Uni-sensor and Uni-station.

1. Start Uni-motion Settings Manager

Launch the Uni-motion Settings Manager, select the COM port, and press the "Connect" button to connect to the Uni-station.

download from here

*In the case of replacement due to sensor failure, etc., delete the sensor number to be replaced before pairing.

"Refresh sensor list" → Select the sensor to be deleted from the list on the left → "Delete selected sensor"

2. Put the sensor in config mode

Put the sensor you want to pair in config mode.

To enter config mode, press and hold the power switch for 5 seconds or longer while the power is on, then release the switch. At this time,The indicator LED flashes about 5 times per second.

*Please note that this is different from the LED flashing in standby mode.

* Unpaired sensors cannot be set to config mode from the Uni-motion setting manager.

config mode

(5 flashes per second)

standby mode

(flashing once every 2 seconds)

3. perform pairing

Pairing is done for all sensors in config mode.

Press the "Start pairing" button on the Uni-motion setting manager, follow the instructions and press the button, then wait for a while to complete the registration.

- Uni-stations are registered in order of connection.

・Sensors already paired with the Uni-station will not be additionally registered.

・It is possible to register in numerical order by setting to config mode one by one and pairing.

・ When registering additional sensors, it is successful if the sensor number is registered up to 08.

・If there is a problem with the registration number, check "Enable move", select the sensor you want to move, and then adjust the number with "Move up" or "Move down".